VPS-100 Pre-Dive vacuum leak check system

Regular Price
$107.00 USD
Sale Price
$107.00 USD
Regular Price
$107.00 USD
Sold Out
Unit Price
Translation missing: en.general.accessibility.unit_price_separator 
Shipping calculated at checkout.
  This product is also available at the European website
www.saltedlineeurope.com


Please read our Warranty Policy.


WARNING  - THIS ACCESSORY IS NOT MEANT TO BE USED UNDERWATER AS PER MANUFACTURER INSTRUCTIONS! ANY ATTEMPT TO DO SO CAN CAUSE EQUIPMENT LOSS AND IS NOT COVERED BY THE WARRANTY!

Compatible models of underwater camera housings:


Included

  • Electronic valve
  • Pump
  • Screwdriver (for battery replacement)


The vacuum pump system checks the water tightness of the underwater camera housing before submerging it.

 

Install the camera inside the underwater camera housing in a dry and low humidity level place.

15-30 minutes before your dive, remove the lid from the backplate to access the vacuum pump system opening (Illustration 1) and ensure the O-ring stays in place. Attach a vacuum pump system to the opening by screwing it clockwise (Illustration 2). Unscrew the lid of the electronic valve (Illustration 3) and press the button to turn on the LED inside the valve (Illustration 4). Attach the rubber part of a pump to the valve and start pumping air out (Illustration 5). The red LED starts blinking, indicating ambient atmospheric pressure. The hand pump is fitted to the threaded valve body, and the air is pumped out of a unit until the red LED changes to green LED and a couple more strokes to ensure sufficient underpressure. The additional stroke or two ensures that the valve is not on the edge of the threshold. The pump is removed, and the protective cap is replaced to ensure airtightness. Observe the green LED blinking for 15 minutes to ensure no air leakage. Unscrew the lid of a valve to access the button, press it for a few seconds to release the pressure from inside, and turn the valve LED off (Illustration 4). Remove the valve from the backplate and place the vacuum opening lid in its original place, making sure the O-ring is still there (Illustration 1). It's safe to dive!